|
|
Rust inside the drivers side of the scuttle was pretty bad but fortunatly it did not go thru the bottom of the inner plenum.
|
New and old section for drivers side of the scuttle.
|
|
|
Passengers side scuttle patch tack welded in, the inside was treated the same way as the floor rails with metal conditioner and red oxide primer.
|
The panels after being repaired and cleaned with metal conditioner were hung for priming.
|
|
|
Wiping down the body in preparation for masking and priming.
|
The body after priming in two pack primer, it was set aside for a few days to allow the primer to full harden.
|
|
|
Applying the x-troll rust preventitive compound a pressure gun is used to force it into all of the joints and seams.
|
Front end fitted and lined up.
|